CanSee Case #2

Bob FischPosted on March 4, 2019 Posted in Hardware — 2 Comments ↓

The first case doesn’t fit 100% – as usual – so I’ve made some improvements before launching the next print. 😉

• 

• 

• 

Share this:

• Click to share on Twitter (Opens in new window)
• Click to share on Facebook (Opens in new window)

Related

‹ CanSee Case

CanSee Case #3 ›

2 comments on “CanSee Case #2”

1. Jeroen Meijer says:

   March 4, 2019 at 8:23 am

   So the mounting screws fit exactly over the veroboard, and it is squeezed between the posts right? Nice solution!

   How will the connector be soldered? Short, thick (stiff) wires?

   Reply
   • Bob Fisch says:

     March 4, 2019 at 10:13 am

     As the connector’s pins do not fit immediately into the veroboard, I will use wires to connect it. At least with this version 😉

     Reply