A DIY CanZE dongle
The KonnWEI dongles are, though the most stable in terms of what you get when you buy, not the best to run CanZE with, especially when fast performance is required. Think like the Driving, Braking and Consumption screens. For the technically inclined: this is because these type of dongles are designed to query, in their own pace, car computers using the ISO-TP protocol, where we had to misuse them to also intercept the raw, operational data. Most of that data can also be obtained through ISO-TP, but again, it would have been slow and we would have to do a lot of reverse engineering to make that work.
And then of course there are a ton of dongles that don’t work at all as they have severely stripped functionality.
With the availability of cheap ESP32 micro-controllers, that can do CAN, WiFi and Bluetooth, time had come to finally build our own hardware. In the next posts, I will describe the hardware, the software and the testing. For now suffice to say that we have something working over Bluetooth, with an unmodified CanZE instance on Android, for under 20 euros hardware, and it is blazing fast.
For those who want to follow in our footsteps and want to build their own dongle, let me start with a shopping list. Especially useful if you order on AliExpress!
- ESP-32 development board. Maybe something like this.
- CANbus transceiver board. Needs to be 3.3 volt, so for instance this.
- Some sort of housing / SAE J1962 (“OBD2”) connector. My advice would be to buy the cheapest dongle you can get and gut it. You should be able to do that for under 3 euros.
- A small 12 to 5 volt converter. While the ESP development board can take 12 volt, that is a maximum and I wouldn’t advice to run it on the car’s 13.5 volt. Example.
- Some veroboard, wire, and other generic craft and soldering stuff.